I still cannot figure out how to have Dual rates and exponential at the same time. I only see one place to set this up, but every time I try to put in expo, it erases my D/R settings. How do I lock in the dual rates and then set up expo?
To set up a dual or triple rates, go to the "D/R" screen under the model menu. Select your control surface you want and then set your rate for normal flying including any expo you want. That sets position 1. Then cursor down to number 2 and select the switch and position you wish to have it operate it. Then go up and set the rate and expo for that position. Then cursor over to number 3 and so on for each rate you want to setup. Remember, you are only setting up your alternate rates for that control surface with the 2, 3, 4 and 5 positions. Do this for each channel and control surface rate you want to setup.
Then move the D/R switch for that control to the position you want to setup. Then set Rate A and Rate B to the amount of D/R you wish for that function. If you want that rate to also have an expo curve, then set the amount of expo. If you leave expo at 0% but change the % of the rates, you will have a linear dual rate.
|
