Radio System FAQ

• 2nd aileron servo programmable for using a 5ch radio & twin servos. In the past the flaperon function required the 2nd aileron servo lead to be plugged into channels 6 or 7. Now in the parameters menu the modeler can select 2nd ail out to be 5 or 6/7.
  
  
• FS data direction changes automatically when throttle channel dir is rev. This change means that if you reverse the direction of your throttle servo using servo reversing, the computer automatically enters your PCM fail safe settings and reverses the position of the auto-kill for your throttle servo. For example, if you have your FS set to bring your throttle servo to 20% from its base, if the programming did not reverse this when you reverse the servo direction, then your FS condition would be 20% from the top of your stick, or an 80% throttle condition.
  
  
• Digital trim buttons now have a beeper when moved past center.
  
  
• Trainer function now has function/normal modes
  
  
• Stop watch now has a power-switch ON mode
  
  
• D/R and Expo are now set individually for left/right and up/down.
  
  
• 5 normal mixes and two 5-point mixes
  
  
• Snap roll function has safety mode

Helicopter

• HELI mode—in condition mode 3 rates are available.
  
  
• 4 swashplate types—SWH1 (std) SWH2 (CCPM) SWH4, SR3, SN3 (see Glossary for added information)
  
  
• Offset rate changes with digitrim when function is activated.
  
  
• 3 offset rates now available (8u only had 2)
  
  
• Gyro mixing ("Gx") has normal and condition modes; the normal mode moves to swa automatically when invert switch is active.
  
  
• Governor mixing now available and has normal and condition modes.

Back to main FAQ/Contact Info page