|
How do I turn off the dial which is affecting, for example, the channel 7 servo?
This is an easy change. Simply assign that channel to NULL, meaning there is no primary control that affects that servo. This way, the servo is ONLY commanded by any mixes which are in place. Here is your example:
- Press Mode/Page to open menu (presse Mode again if in advanced menu)
- Press Cursor Down button if needed to page down to page 2
- Turn then press the dial to select Aux-Ch
- Cursor down one line to channel 7
- Turn dial until reads NULL
- Change any of the assignments for servos 5-9 here as needed.
- Press End to close function
- Press End to close menu
Back to main FAQ/Contact Info page
|
