|
|
Radio System FAQ
I want to set up two servos to operate a single surface, but not use a preset feature like flaperons or ailevators to do so. How can I do this with a mix?
You can use a free mix to set up the twin elevator servos, or any other two-servo combination by simply doing a pmix of the primary channel to the secondary channel at 100% with trim on and link on, offset off and switch assignment NULL so that the mix is always active. Here is an example of mixing 2 to 7:
A. Standard mix from 2 to 7 to work twin elevators:
| ___ | Press Mode (twice if needed) to open Advanced Menu |
| ___ | Dial up or down to a free Programmable Mix and press Dial to select |
| ___ | Cursor Down twice and turn dial LEFT to activate mix |
| ___ | Cursor Down and turn Dial to select channel 2 (elevator) |
| ___ | Cursor Down and turn Dial to select channel 7 (Aux1) |
| ___ | Cursor Down and turn Dial left to turn Link ON |
| ___ | Cursor Down and turn Dial left to turn Trim ON |
| ___ | Cursor Down twice and confirm switch position is NULL |
| ___ | Cursor Down, pull positive elevator, and turn Dial Left to -100% |
| ___ | Push negative elevator, and turn Dial Left to -100% |
| ___ | Press End twice to close Menu |
B. Turn off default control of channel 7 in Aux-Ch screen so VRC does not affect the second elevator servo.
| ___ | Press Mode Button (twice if needed) to open Basic menu |
| ___ | Turn Dial up or down and Press to select Aux Ch |
| ___ | Press Cursor Twice and then turn Dial left until reads CH7 NULL |
| ___ | Press End twice to close Menu |
Back to main FAQ/Contact Info page
|
|
