Triangle Loop

The model starts from upright in the center of the loop, pulls 135 degrees to inverted. The model then performs 1 and 1/2 negative snap rolls to upright, pushes 90 degrees to a 45 degree down line. A 1 and 1/2 negative snap is then performed on this down line, followed by a pull 135 degrees to straight and level at the same altitude as entry.

Click here to view the Triangle Loop video created by Manuel Santos.

Rolling Circle

The model enters upright on a 45 degree up line. The model then executes a 2 roll rolling circle, with the first roll to the outside, and the second to the inside. The model finishes on the same heading as the entry (45 degrees up line).

Click here to view the Rolling Circle video created by Manuel Santos.

Roll/Snap combo

From upright, the model executes a 3/4 roll, followed by a full roll in the opposite direction, and followed by an opposite 3/4 roll to inverted, followed by a 1 and 1/2 negative snap to upright.

Click here to view the Roll/Snap video created by Manuel Santos.